M-F 8a-5:30p PST |
800-442-7454
Crosby IP IPU10 1/2 Ton Lifting Clamp - #2701675Image shown may be a stock photo and is for reference only.

Crosby IP IPU10 1/2 Ton Lifting Clamp - #2701675

Item #:CR-2701675
USUALLY SHIPS:2 - 3 DaysDetails
Price:$560.00
Quantity:
  • Product Description
  • Specifications
  • Attachment(s)
  • Safety Notice
  • Crosby IP IPU10 1/2 Ton Lifting Clamp - #2701675

    • For vertical lifting, turning and transfer, plus a hinged hoisting eye that allows the clamp to lift from practically and direction and helps to avoid side-loading
    • Welded alloy steel body for strength and a small frame size
    • Forged alloy components where it matters most
    • Individually proof-tested at 2 times the Working Load Limit with certification…serial number and test date stamped into body
    • Full 180º turning range for material transfer, turning or moving
    • Latch locks clamp either open or closed
    • Repair kits available
    • RFID equipped for complete, modern traceability
  • MPN
    2701675
    Model
    IPU10
    Type
    Vertical Clamps
    WLL (tons)
    1/2
    WLL (lbs)
    1,100
    Overall Length
    8.98"
    Inside Eye
    1.57"
    Jaw Opening
    0.00" - 0.63"
    Approx. Weight (lbs)
    4.19
  • Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

    Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

    Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.