hOpen Now

Crosby Clamp-Co NS-15 15 Ton Beam Clamp - #2732018

Crosby Clamp-Co NS-15 15 Ton Beam Clamp - #2732018
SKU: CR-2732018MPN: 2732018
  • This product is eligible for FREE SHIPPING.
  • USUALLY SHIPS: 1 - 2 Days
  • Made in the United States of America!
  • This product is rated for overhead lifting.

Product Description

  • Provides an efficient method for handling wide flange beam sections and plate girders
  • When lifting the clamp grips at three points, and when properly balanced and guided, the beam can be handled even if the clamp is slightly off center lengthwise
  • Eliminates the need for slings, chokers and spreader bars
  • Center plate and gripping tongs work together…the heavier the beam, the greater the clamping pressure
  • This model features a recessed base to accept studs welded to the beam surface
  • Individually proof-tested at 2 times the Working Load Limit with certification
  • RFID equipped for complete, modern traceability


Beam Clamps
WLL (tons)
WLL (lbs)
Beam Size
7.00" - 17.00"
Weight (lbs)

Questions & Answers

There are no questions or answers for this item.

Product Reviews

Be the first to write a review!


Safety Notice

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.