hOpen Now

Crosby 404 3" BB Tail Board Snatch Block - 2 Ton WLL - #102016

Crosby 404 3" BB Tail Board Snatch Block - 2 Ton WLL - #102016
SKU: CR-102016MPN: 102016
  • USUALLY SHIPS: 1 - 2 Days
  • Made in the United States of America!
  • This product is rated for overhead lifting.

Product Description

  • Tail board model, not equipped with hook or shackle
  • Opening feature permits insertion of rope while block is suspended from gin-pole
  • Bronze bushing
  • Pressure lube fitting for sheave
  • Fatigue rated


Wire Rope Size
5/16" - 3/8"
Sheave Size
Tail Board Blocks
WLL (tons)
WLL (lbs)
Safety Factor
Weight (lbs)

Questions & Answers

1 Question & 1 Answer
from Gulf Coast asked:
December 19, 2018
Will 1/4" wire rope from winch work on this unit? Usually only max size of cable is listed.
1 Answer
The sheave will certainly accept 1/4" cable, but it will not be 100% efficient. You may notice the cable start to flatten out over time, depending on how heavily it is loaded. It also might fatigue sooner due to the lack of sidewall support. This is common when one tries to run an undersized cable in an oversized sheave.
Submitted by: WRS on December 19, 2018

Product Reviews



Safety Notice

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.