hOpen Now

Landmann 6" Half Side Rigging Block - 5 Ton WLL

Landmann 6" Half Side Rigging Block - 5 Ton WLL
  • USUALLY SHIPS: 1 - 2 Days
  • This product is rated for overhead lifting.
  • This product is imported. Country of Origin subject to change.

Product Description

Half side blocks are a great lightweight option compared to full side blocks. The load capacity does not change, yet the block is much easier to tote. Balanced to "pick up" easily when slack line comes taut--line finds groove quickly. Equipped with roller bearings, which offer a higher load capacity, lower cost and are suitable for slow line speeds.

  • Sheave is made from machined steel
  • Cast sideplates
  • Roller bearing
  • Pressure grease fitting
  • Removable pin at yoke allow for easy opening of the block, and line insertion at any point


Wire Rope Size
3/8" - 1/2"
Sheave Size
Logging Blocks
Bright Green
WLL (tons)
Safety Factor
Weight (lbs)

Questions & Answers

There are no questions or answers for this item.

Product Reviews

Be the first to write a review!

Safety Notice

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.