hOpen Now

CM 5/16" Mid-Grip Wire Rope Clip - #M2547

CM 5/16" Mid-Grip Wire Rope Clip - #M2547
SKU: CM-M2547MPN: M2547


  • USUALLY SHIPS: 1 - 2 Days
  • Made in the United States of America!

Product Description

Hexagon bolt head fits securely into hex-shaped socket for exceptional rotation resistance. This prevents spinning even after repeated use and re-torqueing.

Precise threading on bolt and nut ensures tight alignment and exceptional strength.

Hex bolt is knurled and machine pressed into socket to securely couple with the saddle.

  • Allows for full arc wrench swing for quicker installation, retightening and disassembly
  • Saddles are made of forged steel for strength and wearability--full assembly is mechanical galvanized per ASTM B695-04 Class 25 Type 1
  • Size, manufacturer and trace code are clearly marked on the saddle for easy identification
  • Meets or exceeds performance requirements of FF-C-450 specifications, Type III, Class 1 and will provide maximum holding strength

Proper use of Mid-Grip Clips
  1. Refer to the illustration below when following these instructions. Turn back specified amounts of rope from thimble or loop. Apply first clip one base width from dead end of rope. Tighten nuts evenly, alternating from one nut to the other until reaching the recommended torque.
  2. When two clips are required, apply the second clip as near the loop or thimble as possible. Tighten nuts evenly, alternating until reaching the recommended torque. When more than two clips are required, apply the second clip as near the loop or thimble as possible and turn nuts on second clip firmly, but do not tighten. Proceed to step 3.
  3. When three of more clips are required, space additional clips between the first two and take up rope slack. Then tighten nuts on all clips, alternating from one nut to the other until reaching the recommended torque.
  4. Apply an initial load equal to loads expected in use. Inspect for proper spacing and retighten the nuts to the recommended torque.


Wire Rope Size
Fist-Grip / Mid-Grip
Overall Width
Overall Height
Clips Req'd Per End
Box / Case Quantity
Weight (lbs)

Questions & Answers

There are no questions or answers for this item.

Product Reviews

Be the first to write a review!


Safety Notice

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.