3.5 lbs Dayton pattern single bit axe with 36" straight handle. Dayton pattern so named for the Dayton, Ohio area. A full-sized felling axe for general axe chores. Cutting edge is approximately 4.75" of overall length and the poll is square.
- Head made from forged tool steel
- Hand sharpened, tapered bit for cutting and splitting
- Designed to exceed ANSI standards--edge is Rc 48-55 in hardness at 1.25" back from cutting edge (the poll and eye walls are not hardened and remain in their forged condition)
- Head coated with red enamel and the cutting edge in clear lacquer to deter rust
- American hickory handle, eye section is dried to below 10% moisture content to minimize shrinkage and help prevent loosening
- Axe head is hydraulically seated onto handle and secured with a serrated aluminum wedge--the serrated edge improves bite and the aluminum material is strong, lightweight and does not change size with moisture
- The interior detail of the eye is tapered and allows for a strong mechanical bond (about 1/2" of the handle is actually removed during assembly)
There are no questions or answers for this item.
Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.
Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.
Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.