hOpen Now
View CartCheckout
v
VIEW CART

Crosby 1/4" G-450 Wire Rope Clip - #1010051

Crosby 1/4" G-450 Wire Rope Clip - #1010051
Image shown may be a stock photo and is for reference only.
Crosby 1/4" G-450 Wire Rope Clip - #1010051
SKU: CR-1010051MPN: 1010051
PRICE:$5.62
Wholesale:
PRICE PER:Each
QUANTITY:
  • USUALLY SHIPS: 1 - 2 Days
  • Made in the United States of America!

Product Description

  • The best-known wire rope clip in the industry
  • Each base has a Product Identification Code (PIC) for material traceability, the name CROSBY or CG, and its size forged into it
  • Achieves 80% efficiency of published wire rope breaking strength
  • Entire clip is galvanized to resist corrosion
  • Each is clip is bagged or tagged with proper identification information
  • Satisfies ASME B30.26 requirements
  • Meets Federal Specification FF-C-450 Type I, Class 1


Proper use of Wire Rope Clips
  1. Refer to the illustration below in following these instructions. Turn back specified amount of rope from thimble or loop. Apply first clip on base width from dead end of rope. Apply U-bolt over dead end of wire rope live end rests in saddle. Tighten nuts evenly, alternate from one nut to the other until reaching the recommended torque.
  2. When two clips are required, apply the second clip as near the thimble or loop as possible. Tighten nuts evenly, alternating until reaching the recommended torque. When more than two clips are required, apply the second clip as near the loop or thimble as possible, turn nuts on second clip firmly, but do not tighten. Proceed to Step 3.
  3. When three or more clips are required, space additional clips equally between the first two take up rope slack tighten nuts on each U-bolt evenly, alternating from one nut to the other until reaching the recommended torque.
  4. Apply initial load equal to loads expected in use. Inspect for proper orientation and spacing of clips and retighten the nuts to recommended torque.

Specifications

MPN
1010051
Model
G-450
Wire Rope Size
1/4"
Type
Forged
Overall Width
1.43"
Thread
0.31"
Clips Req'd Per End
2
Box / Case Quantity
100
Weight (lbs)
0.19

Questions & Answers

There are no questions or answers for this item.


Show Questions & Answers

Product Reviews

Crosby 1/4" G-450 Wire Rope Clip - #1010051$5.62
No reviews yet 
Show Product Reviews

Video

Attachments

Safety Notice

Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.