hOpen Now

Crosby M10 SL-150 Slide-Loc Lifting Point - 0.5T WLL - #1068515

Crosby M10 SL-150 Slide-Loc Lifting Point - 0.5T WLL - #1068515Crosby M10 SL-150 Slide-Loc Lifting Point - 0.5T WLL - #1068515Crosby M10 SL-150 Slide-Loc Lifting Point - 0.5T WLL - #1068515
SKU: CR-1068515MPN: 1068515
  • USUALLY SHIPS: 1 - 2 Days
  • This product is rated for overhead lifting.
  • Made in France

Product Description

What Is the Slide-Loc?
If a hoist ring and a machinery eye bolt had a baby, this would be it. One common problem for riggers is that eye bolts do not offer enough flexibility (no swiveling and angular loads greatly reduce capacity), and hoist rings are often too expensive for a given job. Crosby recognized this problem and came up with a great, unique solution. Enter the SL-150 Slide-Loc Lifting Point.

Is it Complicated to Use?
Quite the contrary, in fact, we don't think it could be any easier. To install the Slide-Loc, make sure the red indicator is showing, which means the bolt and bail are engaged. Simply hand tighten the unit, no special tools required. Move the tab to cover the red indicator, and allow the bail to swivel while under load. The Slide-Loc is now ready for use. To remove, simply move the tab to expose the red tab and unthread the Slide-Loc from its installation point.

Check out the bullet points below for informational highlights, and check out the Video and Attachments tab for further information.

  • Patent-pending locking mechanism slides to lock bolt for installation, or release the bolt for swiveling during lift
  • Red indicator on side of Slide-Loc indicates the bolt is ready for installation--meaning the bolt is engaged with the bail for easy tightening
  • Hand tightening is sufficient, no special tools are required
  • Bail will swivel 360º when in use (red indicator is covered and not showing), and the bail has a larger opening that a standard eye bolt
  • Working Load Limits stays at 100% even at 90º
  • Bail is forged alloy steel, Quenched and Tempered
  • Fatigue rated at 1-1/2 times the Working Load Limit at 20,000 cycles
  • Replaceable, and even longer bolts are available by special order


Alloy Steel
Platinum / Black
WLL (tons)
Safety Factor
Inside Length
28.0 mm
Inside Width
27.8 mm
14.6 mm
Bail Size
8.5 mm
Weight (kg)

Questions & Answers

There are no questions or answers for this item.

Product Reviews



Safety Notice

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.