hOpen Now

Duckbill 68-DB1 1/8" x 2.5 ft Earth Anchor - 1100 lbs Capacity

Duckbill 68-DB1 1/8" x 2.5 ft Earth Anchor - 1100 lbs CapacityDuckbill 68-DB1 1/8" x 2.5 ft Earth Anchor - 1100 lbs CapacityDuckbill 68-DB1 1/8" x 2.5 ft Earth Anchor - 1100 lbs CapacityDuckbill 68-DB1 1/8" x 2.5 ft Earth Anchor - 1100 lbs Capacity
SKU: MCP-F830135MPN: F830135

 By checking this box, I understand I am placing a pre-order for an out of stock product and agree to the pre-order terms & conditions.
QuantityCost per AnchorSave
1 - 23$8.90-
24 + $8.465%
  • USUALLY SHIPS: 1 - 2 Days
  • Made in the United States of America!

Product Description

  • Works like a toggle bolt in soil
  • Driven into the ground (with no holes, no digging and no concrete), providing a safe and environmentally sensitive installation
  • An upward pull on the anchor tendon rotates the Duckbill into a perpendicular "anchor lock" position in undisturbed soil
  • Results in superb holding capacities
  • A very effective, lightweight and economical solution to any anchoring application, large or small
  • A favorite for our arborist customers, great for anchoring and supporting trees
  • Working Load Limit (WLL) shown indicates holding power in normal soil
  • Breaking Strength shown indicates the maximum tensile strength of the included wire rope

* Capacities shown apply only to normal soil conditions.


1/8" x 2.5 ft
WLL (lbs)
Breaking Strength (lbs)
Box / Case Quantity
Weight (lbs)

Questions & Answers

3 Questions & 3 Answers
from Mansfield, MA asked:
May 1, 2021
What size driving rod do I need?
1 Answer
For the model 68 head, you need the DS-68 1/2" Drive Rod, part number MCP-F830900.
Submitted by: WRS on May 1, 2021

from Austin, TX asked:
July 9, 2019
How long is the wire?
1 Answer
The wire rope portion measures 30" from end to end.
Submitted by: WRS on July 11, 2019

from East, TN asked:
June 19, 2018
Would this be suitable for deadman application for a low retaining wall that is 2 to 4 ft high?
1 Answer
Possibly, yes. We have no way of calculating the load that will be placed on the anchor in your application. Provided it does not exceed the anchor's published strength, you should be fine. It's always recommended to leave a safety factor of at least 2:1. These anchors are meant to be permanently left installed.
Submitted by: WRS on June 19, 2018

Product Reviews

5 Reviews
100% (5)
0% (0)
0% (0)
0% (0)
0% (0)
100% Recommend this product (5 of 5 responses)
By Ken
Central New York
Worked well in rocky conditions
July 11, 2021
Pre-drilled a smaller diameter hole than the size of the anchor to aid in driving in the anchor. Worked like a charm!!
By Dave
Yakima, WA
Exactly perfect for what we needed
April 18, 2021
We used four 68-DB1 to anchor the corners of a 6' X 7' playhouse. Very easy to install and to anchor to corners.

Merchant Response:Thanks for the review Dave, and we LOVE the photo!!!
  • Easy to use. We used a hand sledge to pound them in. It took about 1 minute each. Shipping was lightning quick.
  • None
By Louis
Duck Bill Ground Anchors in a Retaining Wall
October 24, 2019
After being quoted $7500 for a new 38 foot long, 4 foot high retaining wall to replace the old rail road tie one that had rotted out, we devised our own using the Duck Bill Ground Anchors. After installing 10, 4x4 treated wood posts at 4 foot intervals and then cladding them with TREX composite decking horizontally over the 39 foot span to keep the soil in place, we then installed one Duck Bill 48" from each post at about a 30 degree angle with the the loop facing each post. We then added eye bolts to the top/center face of each post, attached a heavy duty stainless turnbuckle to each eye bolt and then ran 1/8th inch wire rope from the turnbuckle to the loop end of the Duck Bill using a thimble within each loop. We did have to trim the 1/8th inch thimbles to fit inside each loop, though. We pulled the rope tight and then tightened each turnbuckle until the rope sections were tight. The Duck Bills provided a great solid anchor point to keep the posts in place and prevent any outward movement of the posts. Even our landscaper said it was a GREAT way to put in the wall. Total costs by using the Duck Bills.....$1600 for everything. A great product.
  • Good, solid anchor that will not lift out of the ground if installed correctly (easy to do).
  • Inexpensive but good quality.
  • Fast shipping.
  • The loop at the end needs to be slightly larger to accommodate an 1/8th inch thimble.
By Gary
Silver City, NM
Great Product
October 12, 2019
Excellent product. Durable, strong, easy to install.
  • Inexpensive, easy, fast, strong
By Gary
Claremore, OK
Excellent Product - just as advertised
September 8, 2019
Very good product used to guy trees, anchor a greenhouse and storage building.



Safety Notice

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.