hOpen Now

Crosby L-3322B 3 Ton Alloy Ball Bearing Swivel Hook w/ Latch - #1028618

Crosby L-3322B 3 Ton Alloy Ball Bearing Swivel Hook w/ Latch - #1028618
SKU: CR-1028618MPN: 1028618
  • USUALLY SHIPS: 1 - 2 Days
  • Made in the United States of America!
  • This product is rated for overhead lifting.

Product Description

  • New anti-friction bearing design allows hook to rotate freely under load
  • Forged steel, Quenched and Tempered, load-rated
  • Proof-tested at 2.5 times Working Load Limit
  • Careful design and engineering yields tremendous strength-to-weight ratio, no unnecessary bulk
  • Low profile hook tip uses the standard S-4320 Latch Kit…latch can be added or replaced even years after a hook purchase
  • QUIC-CHECK markings are incorporated…Deformation Indicators check for stretch in throat opening and Angle Indicators assist users in lifting within tolerance of load angles


Slip / Sling
WLL (tons)
WLL (lbs)
Safety Factor
Overall Length
Reach (B-B)
Inside Eye
2.00"W x 1.56"L
Throat Opening
Weight (lbs)

Questions & Answers

1 Question & 1 Answer
from Dayton, VA asked:
August 6, 2019
Do you sell replacement latch kits for these hooks?
1 Answer
Yes, the replacement latch can be ordered at this link.
Submitted by: WRS on August 6, 2019

Product Reviews


Safety Notice

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.