The FHX-V line of clamps is almost the same as the regular FHX line of horizontal clamps, with one key difference. These clamps feature a pre-tensioned spring cam that allows one operator to place the clamp and guide the hoist, whereas traditional horizontal clamps are more difficult to manipulate and require two sets of hands, or a lot of shuffling to set the clamp and use the hoist all at the same time. Used for horizontal lifting and transporting of steel plates and other non-deflecting materials. These clamps should always be used in pairs (a minimum of two clamps per lift), and the Working Load Limits shown below are based on one pair of clamps, not per piece. Available in with jaw openings from 0.00" - 2.36", and a range of capacities, from 1 - 6 tons.