hOpen Now
View CartCheckout

Marvin Pruner Return Spring

Marvin Pruner Return Spring
Image shown may be a stock photo and is for reference only.
Marvin Pruner Return Spring
SKU: MV-Z104MPN: Z104
  • USUALLY SHIPS: 1 - 2 Days
  • Made in the United States of America!

Product Description

  • Main return spring for standard Marvin PH4 pruner head
  • Does not fit QCB or PH5 pruner heads



Questions & Answers

1 Question & 1 Answer
from Plymouth, MI asked:
June 13, 2018
I am looking for a spring to repair my broken pole saw. It needs to have a relaxed length of 3.5". Can you advise if this one will fit?
1 Answer
The relaxed length of this spring is 3" end-to-end. We recommend looking at the Phoenix Pruner Spring which has a relaxed length of 3.5".
Submitted by: WRS on June 15, 2018

Show Questions & Answers

Product Reviews

Marvin Pruner Return Spring$3.90
5 stars based on 1 reivew 
Marvin pole pruner part 5
Replaced a broken return spring. The part was very reasonably priced and arrived quickly. The price and shipping cost were both lower than other suppliers, so I will order again in the future.
Pros:Fast delivery and reasonable prices.
0 of 0 found this review helpful Was this review helpful to you? Yes / No
Show Product Reviews

Safety Notice

Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.