hOpen Now

Crosby IP IPTK 3 Ton Beam Clamp - #2700997

Crosby IP IPTK 3 Ton Beam Clamp - #2700997
SKU: CR-2700997MPN: 2700997
  • This product is eligible for FREE SHIPPING.
  • USUALLY SHIPS: 1 - 2 Days
  • This product is rated for overhead lifting.
  • Made in The Netherlands

Product Description

  • For the transfer of steel beams and attachments of tackle eye
  • Welded alloy steel body for strength and a small frame size
  • Forged alloy components where it matters most
  • Individually proof-tested at 2 times the Working Load Limit with certification…serial number and test date stamped into body
  • Repair kits available
  • RFID equipped for complete, modern traceability


Beam Clamps
WLL (tons)
WLL (lbs)
Beam Size
3.00" - 7.50"
Inside Eye
Weight (lbs)

Questions & Answers

1 Question & 1 Answer
from Eau Claire, WI asked:
July 8, 2020

Can this clamp be used to lift beams into position with a crane?  If so does it state this in the paperwork that is shipped with it?

1 Answer
Yes, these clamps were designed for lifting beams.  Please view the PDF at this link for specs and details.
Submitted by: WRS on July 10, 2020

Product Reviews

Be the first to write a review!


Safety Notice

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.