The internal taper of a Rigguy Wire Stop fits over the middle strand of 1x7 EHS Strand Cable
, with the six remaining strands surrounding it. This "small" size in particular fits 3/16" - 1/4" cable.
The more pressure that is applied, the deeper into the block the strand and taper are pulled. The block itself is made of 6061 AL, while the taper is made of 416 SS for strength of application and corrosion resistance. Although the wire stop is only 1-1/4" long, it holds close to 100 percent of the Breaking Strength of the strand itself.
The Wire Stop eliminates the need for the j-lags, eye bolts, hooks, thimbles, clips and Tree-Grip Dead-ends
. It can be used in more applications because it is secured on the outside of the limb or trunk. Because of its small size and simplicity, it makes for a clean, clutter-free installation.
Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.
Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.
Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.