hOpen Now
W R S
#

1/2" Stainless Steel Screw Pin Anchor Shackle - 2 Ton WLL

1/2" Stainless Steel Screw Pin Anchor Shackle - 2 Ton WLL
SKU: IMP-SPASS012
$16.23
Quantity
QuantityCost per ShackleSave
1 - 24$16.23-
25 + $14.6110%
  • USUALLY SHIPS: 1 - 2 Days
  • This product is rated for overhead lifting.
  • This product is imported. Country of Origin subject to change.

Product Description

  • Maximum corrosion resistance
  • Load-rated for overhead lifting
  • Oversize screw pin
  • Meets Federal Specification RR-C-271F, Type IV A, Class 2

Specifications

Size
1/2"
Type
Screw Pin Anchor
Material
Stainless Steel 316
Color
Silver
WLL (tons)
2
WLL (lbs)
4,000
Inside Length
1.83"
Throat Opening
0.82"
Pin Diameter
0.63"
Weight (lbs)
0.68

Questions & Answers

1 Question & 1 Answer
Scott
from Westminster, CO asked:
January 26, 2020
The pin is 1/2 inch in diameter, correct?
1 Answer
No, if you scroll down the page and look at the product specifications tab, you will see the pin diameter is 0.63", or 5/8".‚  The 1/2" callout refers to the bale and is just the nominal size.‚  For "most" shackles, the pin diameter is the next size up compared to the nominal size of the shackle.
Submitted by: WRS on January 26, 2020

Product Reviews

Safety Notice

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.