hOpen Now

Gunnebo 2" MT-16-10 Grade 100 Sub Assembly - 77000 lbs WLL - #Z100906

Gunnebo 2" MT-16-10 Grade 100 Sub Assembly - 77000 lbs WLL - #Z100906
SKU: GN-Z100906MPN: Z100906
  • This product is eligible for FREE SHIPPING.
  • USUALLY SHIPS: 1 - 2 Days
  • This product is rated for overhead lifting.
  • Made in Sweden
Purchase over $500 of Gunnebo Johnson products and use Promo Code: GUNNEBO10 to receive a 10% discount off your order total! *Restrictions may apply

Product Description

  • Primary (aka top) master link is extra-wide to allow a better fit on large crane hooks
  • Secondary (aka bottom) links are oversized to accommodate multiple fittings without excessive crowding
  • Ideal for use with Grade 80 / 100 chain slings, also great for wire rope slings
  • Individually proof-tested at 2 times the Working Load Limit
  • Heat number identification allows full product traceability

* Refer to PDF attachment for full specifications on both top and bottom link dimensions.


Chain Diameter
Sub Assembly
Grade 100 Alloy Steel
WLL (lbs)
Safety Factor
Reach (B-B)
Inside Width
Weight (lbs)

Questions & Answers

There are no questions or answers for this item.

Product Reviews


Safety Notice

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.