M-F 8a-5:30p PST |
Gunnebo 7/8" MT-8-10 Grade 100 Sub Assembly - 17600 lbs WLLImage shown may be a stock photo and is for reference only.

Gunnebo 7/8" MT-8-10 Grade 100 Sub Assembly - 17600 lbs WLL

Item #:GN-589631
USUALLY SHIPS:24hrsDetails
  • This product is eligible for FREE SHIPPING on orders over $199.
  • This product is rated for overhead lifting.
  • Made in Sweden
Purchase over $500 of Gunnebo Johnson products and use Promo Code: GUNNEBO10 to receive a 10% discount off your order total! *Restrictions may apply
  • Product Description
  • Specifications
  • Attachment(s)
  • Safety Notice
  • Gunnebo 7/8" MT-8-10 Grade 100 Sub Assembly - 17600 lbs WLL

    • Primary (aka top) master link is extra-wide to allow a better fit on large crane hooks
    • Secondary (aka bottom) links are oversized to accommodate multiple fittings without excessive crowding
    • Ideal for use with Grade 80 / 100 chain slings, also great for wire rope slings
    • Individually proof-tested at 2 times the Working Load Limit
    • Heat number identification allows full product traceability
  • MPN
    Chain Diameter
    9/32" (1/4") - 5/16"
    Sub Assembly
    Grade 100 Alloy Steel
    WLL (lbs)
    Safety Factor
    Reach (B-B)
    Inside Width
    Approx. Weight (lbs)
  • Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

    Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

    Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.
  • Refer to PDF attachment for full specifications on both top and bottom link dimensions.