M-F 8a-5:30p PST |
Miller 1.5T Bullet Nose Angular Contact Bearing Swivel - 3000 lbs WLLImage shown may be a stock photo and is for reference only.

Miller 1.5T Bullet Nose Angular Contact Bearing Swivel - 3000 lbs WLL

Item #:MRB-B-414
USUALLY SHIPS:3 - 5 DaysDetails
  • This product is eligible for FREE SHIPPING on orders over $199.
  • Made in the United States of America!
  • This product is rated for overhead lifting.

  • Product Description
  • Specifications
  • Attachment(s)
  • Safety Notice
  • Miller 1.5T Bullet Nose Angular Contact Bearing Swivel - 3000 lbs WLL

    • First ever angular contact bearing design-- developed 1st by Miller
    • Multiple angular contact bearing design extends the life of wire rope and maximizes efficiency, reliability and service life
    • Lowest starting torque for faster response and higher rotational speeds
    • Structural components machined from forged alloy steel--not cast
    • Zinc-plated inside and out for effective protection against corrosion
    • Individually proof-tested at 2 times the Working Load Limit
  • MPN
    Wire Rope Size
    Bullet Nose
    WLL (tons)
    WLL (lbs)
    Safety Factor
    Overall Length
    Reach (B-B)
    Inside Eye
    Jaw Opening
    Pin Diameter
    Approx. Weight (lbs)
  • Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

    Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

    Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.
  • Price shown is for one swivel. Above image shows one swivel pictured from two angles for reference only.