hOpen Now

1/2" x 20 ft Grade 70 Tie Down Chain - 11300 lbs WLL

1/2" x 20 ft Grade 70 Tie Down Chain - 11300 lbs WLL
QuantityCost per ChainSave
1 - 9$123.86-
10 + $115.197%
  • USUALLY SHIPS: 1 - 2 Days
  • This product is imported. Country of Origin subject to change.

Product Description

  • Made from Grade 70 transport chain
  • Yellow chromate finish for corrosion protection
  • Suitable for load securement / tie down
  • Pre-cut with clevis grab hooks installed on each end


Chain Diameter
Clevis Hooks
Grade 70
Length (ft)
WLL (lbs)
Weight (lbs)

Questions & Answers

1 Question & 1 Answer
from Lowell, MA asked:
December 17, 2020
What's better for rust protection, this or galvanized?
1 Answer
Hot dip galvanized chain is definitely more resistant to rust than your standard zinc-plated or chromate chain.  However, it's usually only found in Grade 43 or lower, especially for tie down purposes (there are some higher grade galvanized marine chains).  Grade 43 is weaker than Grade 70 and generally not legal for tie down, so the two chains are not exactly interchangeable when it comes to application.
Submitted by: WRS on December 19, 2020

Product Reviews

Safety Notice

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.