hOpen Now

Crosby 3/8" G-429N Fist-Grip Wire Rope Clip - #1010514

Crosby 3/8" G-429N Fist-Grip Wire Rope Clip - #1010514
SKU: CR-1010514MPN: 1010514
  • USUALLY SHIPS: 1 - 2 Days
  • Made in the United States of America!

Product Description

  • Entire clip is galvanized to resist corrosive and rusting action
  • Achieves 80% efficiency of published wire rope breaking strength
  • Bolts are an integral part of the saddle
  • Saddle is made from forged steel
  • Nuts can be installed in such a way as to enable the operator to swing the wrench in a full arc for fast installation
  • Assembled with standard heavy hex nuts
  • Satisfies ASME B30.26 requirements
  • Meets Federal Specification FF-C-450 Type III, Class 1

Proper use of Fist-Grip Clips
  1. Refer to the illustration below when following these instructions. Turn back specified amounts of rope from thimble or loop. Apply first clip one base width from dead end of rope. Tighten nuts evenly, alternating from one nut to the other until reaching the recommended torque.
  2. When two clips are required, apply the second clip as near the loop or thimble as possible. Tighten nuts evenly, alternating until reaching the recommended torque. When more than two clips are required, apply the second clip as near the loop or thimble as possible and turn nuts on second clip firmly, but do not tighten. Proceed to step 3.
  3. When three of more clips are required, space additional clips between the first two and take up rope slack. Then tighten nuts on all clips, alternating from one nut to the other until reaching the recommended torque.
  4. Apply an initial load equal to loads expected in use. Inspect for proper spacing and retighten the nuts to the recommended torque.


Wire Rope Size
Fist-Grip / Mid-Grip
Galvanized Steel
Overall Width
Clips Req'd Per End
Box / Case Quantity
Weight (lbs)

Questions & Answers

There are no questions or answers for this item.

Product Reviews



Safety Notice

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.