hOpen Now

Junior Double Ender Link Hook - 7/8" - 1-1/4" Wire Rope

Junior Double Ender Link Hook - 7/8" - 1-1/4" Wire RopeJunior Double Ender Link Hook - 7/8" - 1-1/4" Wire RopeJunior Double Ender Link Hook - 7/8" - 1-1/4" Wire Rope
  • USUALLY SHIPS: 1 - 2 Days
  • This product is imported. Country of Origin subject to change.

Product Description

  • Double ender line hooks are used in logging to join lines with ferrules on each end (see illustration above)
  • Works only with "Junior" size ferrules, which can be found on line as small as 7/8" and as large as 1-1/4"
  • Commonly used to join guylines

* The most common sizes of wire rope that we see used with these couplers are 1-1/8" and 1-1/4" 6x19 Class XIP IWRC wire rope. If you are using high performance swaged wire rope, or if you are unsure about the OSHA regulations in the state where you are operating, then please consult with local officials to be sure your guylines, nubs and couplers are all in compliance.


Wire Rope Size
7/8" - 1-1/4"
Double Enders
Weight (lbs)

Questions & Answers

There are no questions or answers for this item.

Product Reviews

Safety Notice

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.