hOpen Now

Chicago 1" x 6" Shoulder Screw Eye Bolt - #08940 1

Chicago 1" x 6" Shoulder Screw Eye Bolt - #08940 1
SKU: CH-089401MPN: 08940 1
  • USUALLY SHIPS: 1 - 2 Days
  • Made in the United States of America!
Purchase over $500 of Chicago products and use Promo Code: CHICAGO10 to receive a 10% discount off your order total! *Restrictions may apply

Product Description

  • Drop forged and heat-treated steel
  • Hot-dip galvanized
  • Supplied with cone point
  • Lag screw thread


08940 1
1" x 6"
Screw / Lag
Overall Length
Overall Width
Inside Eye
Weight (lbs)

Questions & Answers

1 Question & 1 Answer
from Summerifled, FL asked:
June 26, 2020

I am not able to find any lag shields for 1" screws, so how can this be anchored into an existing concrete floor?  Would this stand up to a large bolt cutter?

1 Answer
Unfortunately we do not get into lag shields, and we don't have any instructions for installing this eye bolt into a concrete floor.  We are fairly confident, however, that this eye bolt would simply be too large for most bolt cutters to even get a proper bite.  However, it's not hardened like security chain is.
Submitted by: WRS on June 29, 2020

Product Reviews


Safety Notice

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Although Westech Rigging Supply strives to manufacture and sell the highest quality rigging and safety gear, use of the gear is dangerous if not used correctly by competent trained professionals. Westech Rigging Supply disclaims any liability resulting from the misuse of its rigging and safety gear. Please take a moment to more thoroughly review our disclaimer.

Westech Rigging Supply rigging and safety gear is only intended to be used by competent trained professionals. Misuse of the rigging and safety gear can result in serious injury up to and including loss of life. As such, Westech Rigging Supply disclaims liability for any misuse or incorrect product selection by our customers.

Rigging and safety gear purchased from Westech Rigging Supply should be used in strict accordance with all industry and OSHA standards. At no time should rigging or safety gear be used beyond its certified load ratings (aka Working Load Limits). Normal wear and tear should be expected with use of rigging and safety gear; therefore, all gear should be thoroughly inspected before each and every use. Worn or unsafe rigging and safety gear should never be used.